APRS Track Direct

My position About ☰

reset

HS6GVH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS6GVH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1732311226	-81 dBm	11.96 V
1732310604	-78 dBm	11.96 V
1732310110	-79 dBm	11.94 V
1732309360	-77 dBm	11.96 V
1732308738	-81 dBm	11.98 V
1732308116	-80 dBm	11.96 V
1732307494	-80 dBm	11.94 V
1732306872	-80 dBm	11.94 V
1732306250	-79 dBm	11.94 V
1732305628	-78 dBm	11.96 V
1732305006	-78 dBm	11.96 V
1732304384	-78 dBm	11.96 V
1732303762	-80 dBm	11.96 V
1732303140	-79 dBm	11.94 V
1732302518	-78 dBm	11.94 V
1732301896	-78 dBm	11.94 V
1732301274	-77 dBm	11.94 V
1732300652	-78 dBm	11.94 V
1732300030	-80 dBm	11.94 V
1732299408	-78 dBm	11.94 V
1732298786	-78 dBm	11.94 V
1732298164	-77 dBm	11.94 V
1732297544	-77 dBm	11.94 V
1732296920	-78 dBm	11.96 V
1732296298	-80 dBm	11.94 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)