APRS Track Direct

My position About ☰

reset

SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786751046	65 Count	636 Count	44 Count
1786750146	62 Count	593 Count	42 Count
1786749260	55 Count	559 Count	40 Count
1786748360	52 Count	524 Count	38 Count
1786747459	49 Count	492 Count	36 Count
1786746558	46 Count	462 Count	34 Count
1786745658	42 Count	415 Count	31 Count
1786744757	39 Count	373 Count	29 Count
1786743856	36 Count	323 Count	27 Count
1786742955	33 Count	286 Count	25 Count
1786742055	30 Count	254 Count	23 Count
1786741154	26 Count	222 Count	20 Count
1786740253	20 Count	191 Count	15 Count
1786739353	17 Count	160 Count	13 Count
1786738452	15 Count	127 Count	12 Count
1786737551	11 Count	93 Count	9 Count
1786736651	7 Count	63 Count	6 Count
1786735750	3 Count	33 Count	3 Count
1786734849	143 Count	1001 Count	111 Count
1786733949	139 Count	959 Count	108 Count
1786733048	136 Count	928 Count	106 Count
1786732147	134 Count	890 Count	105 Count
1786731246	131 Count	858 Count	103 Count
1786730346	128 Count	837 Count	101 Count
1786729445	123 Count	810 Count	97 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)