APRS Track Direct

My position About ☰

reset

SP2KDS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2KDS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790636656	53 Count	882 Count	32 Count
1790634856	51 Count	831 Count	31 Count
1790633056	49 Count	775 Count	30 Count
1790631286	44 Count	773 Count	30 Count
1790629485	42 Count	729 Count	29 Count
1790627684	39 Count	683 Count	28 Count
1790624083	35 Count	602 Count	26 Count
1790622283	34 Count	550 Count	26 Count
1790620482	32 Count	511 Count	25 Count
1790618681	30 Count	470 Count	24 Count
1790616881	28 Count	429 Count	23 Count
1790615080	26 Count	384 Count	22 Count
1790613279	23 Count	335 Count	20 Count
1790611479	11 Count	236 Count	9 Count
1790609678	9 Count	166 Count	8 Count
1790607877	7 Count	95 Count	7 Count
1790606077	89 Count	1024 Count	74 Count
1790604276	85 Count	953 Count	71 Count
1790602476	82 Count	874 Count	70 Count
1790600675	60 Count	761 Count	49 Count
1790598874	33 Count	675 Count	23 Count
1790597074	19 Count	608 Count	10 Count
1790595273	17 Count	576 Count	9 Count
1790593472	15 Count	472 Count	8 Count
1790591672	13 Count	431 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)