APRS Track Direct

My position About ☰

reset

ON4CDR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4CDR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1774622684	348 Count	393 Count
1774621869	175 Count	198 Count
1774621781	326 Count	370 Count
1774620878	306 Count	343 Count
1774619975	283 Count	318 Count
1774619779	151 Count	175 Count
1774619071	261 Count	290 Count
1774618166	240 Count	269 Count
1774617688	131 Count	151 Count
1774617262	218 Count	249 Count
1774616359	197 Count	232 Count
1774615454	175 Count	198 Count
1774614551	151 Count	175 Count
1774614260	107 Count	129 Count
1774613647	131 Count	151 Count
1774612745	107 Count	129 Count
1774611841	88 Count	95 Count
1774610937	67 Count	71 Count
1774610034	44 Count	50 Count
1774609411	643 Count	881 Count
1774609131	22 Count	40 Count
1774608228	786 Count	1021 Count
1774607324	757 Count	990 Count
1774606422	737 Count	971 Count
1774605518	715 Count	953 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)