APRS Track Direct

My position About ☰

reset

N8FLA-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N8FLA-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	DigiRpt*	Temp*
1753771367	262 Pkts	54 Pkts	60 C
1753765652	282 Pkts	44 Pkts	53 C
1753762052	202 Pkts	17 Pkts	53 C
1753758452	224 Pkts	20 Pkts	53 C
1753754852	202 Pkts	23 Pkts	52 C
1753751252	175 Pkts	21 Pkts	53 C
1753747652	263 Pkts	33 Pkts	55 C
1753744052	274 Pkts	30 Pkts	67 C
1753740452	254 Pkts	20 Pkts	67 C
1753736853	235 Pkts	22 Pkts	66 C
1753733253	230 Pkts	17 Pkts	67 C
1753729653	234 Pkts	21 Pkts	67 C
1753726053	263 Pkts	20 Pkts	67 C
1753722453	278 Pkts	21 Pkts	68 C
1753718853	277 Pkts	17 Pkts	68 C
1753715253	294 Pkts	14 Pkts	69 C
1753711653	309 Pkts	21 Pkts	69 C
1753708053	343 Pkts	40 Pkts	70 C
1753704453	403 Pkts	56 Pkts	66 C
1753700853	401 Pkts	109 Pkts	60 C
1753697253	414 Pkts	120 Pkts	61 C
1753693653	324 Pkts	61 Pkts	60 C
1753689864	286 Pkts	30 Pkts	52 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)