APRS Track Direct

My position About ☰

reset

W3GV-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W3GV-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786731304	178	29	27	23	43
1786730405	178	29	27	24	43
1786725006	178	29	27	24	43
1786724104	178	29	27	23	43
1786718704	178	29	27	23	43
1786717805	178	29	27	24	43
1786716904	178	29	27	23	43
1786716005	178	29	27	24	44
1786714207	178	29	28	24	44
1786713304	178	29	27	23	43
1786712405	178	29	27	24	43
1786711504	178	29	27	23	43
1786710605	178	29	27	24	44
1786709705	178	29	27	23	43
1786708808	178	29	28	24	45
1786707905	178	29	27	23	43
1786707006	178	29	27	24	44
1786706105	178	29	27	23	44
1786705206	178	29	27	24	44
1786704305	178	29	27	23	43
1786703407	178	29	28	24	46
1786702504	178	29	27	23	43
1786701605	178	29	27	24	45
1786700706	178	29	27	23	43
1786699805	178	29	27	24	45

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)