APRS Track Direct

My position About ☰

reset

VK2WIC-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2WIC-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786722259	128	12	145	131	121
1786722062	128	12	142	128	119
1786721241	128	12	142	127	118
1786720420	128	13	142	127	117
1786719599	128	12	143	127	117
1786717957	129	12	141	127	118
1786717136	128	12	141	127	117
1786716315	128	12	143	129	119
1786715494	129	13	142	128	118
1786714673	129	13	141	127	118
1786713852	128	13	142	128	117
1786713031	129	13	142	126	116
1786712210	129	13	142	127	117
1786711389	129	14	142	127	117
1786710568	129	14	141	127	117
1786708926	129	13	142	127	117
1786708105	129	14	142	128	118
1786707284	129	13	143	128	118
1786706463	129	13	141	127	118
1786705642	129	13	143	128	117
1786704821	129	13	142	127	118
1786703179	129	13	142	127	117
1786702358	129	14	143	127	117
1786701537	130	14	143	128	118
1786700716	130	14	142	127	117

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)