APRS Track Direct

My position About ☰

reset

VE7ILZ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE7ILZ. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1778047716	66	64	67	33	40
1778044115	67	66	68	33	39
1778042315	64	64	70	33	40
1778040515	71	66	70	33	39
1778036913	66	65	70	33	40
1778033312	66	66	70	33	39
1778029712	71	65	69	33	39
1778027911	63	64	82	34	40
1778026111	74	66	71	33	39
1778024316	70	65	69	33	39
1778022509	65	65	70	33	40
1778020709	68	67	71	33	39
1778018909	68	67	70	33	40
1778017108	64	66	68	33	40
1778015308	79	68	71	33	39
1778013508	65	65	69	33	40
1778011707	66	66	68	33	40
1778008106	73	67	71	33	40
1778004506	68	67	73	33	39
1778000905	70	69	71	33	39
1777999105	70	68	81	33	58
1777995504	66	83	68	33	40
1777990101	64	64	66	33	40
1777986500	68	66	71	33	40
1777984700	67	65	67	33	40

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)