APRS Track Direct

My position About ☰

reset

K1OSH-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K1OSH-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732310302	141	53	255	105	84
1732309701	142	52	255	106	85
1732309100	142	51	255	106	85
1732308498	138	50	255	106	85
1732306694	138	51	255	106	85
1732306092	137	51	255	106	85
1732305491	138	50	255	106	85
1732304889	136	50	255	106	85
1732303686	137	50	255	106	85
1732302483	138	49	255	107	86
1732301280	135	48	255	107	86
1732300679	135	48	255	107	86
1732300077	134	48	255	107	86
1732298874	135	47	255	108	87
1732298273	133	47	255	108	87
1732297671	132	46	255	108	87
1732297070	130	46	255	108	87
1732296468	128	46	255	108	88
1732295265	127	46	255	109	87
1732294664	126	46	255	109	87
1732294064	126	46	255	109	87
1732293461	126	46	255	109	87
1732292859	126	46	255	109	87
1732292258	125	46	255	109	87
1732291656	125	46	255	109	87

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)