APRS Track Direct

My position About ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790631889	158 Count	538 Count	79 Count
1790630986	156 Count	533 Count	78 Count
1790630082	154 Count	527 Count	77 Count
1790629179	152 Count	522 Count	76 Count
1790628276	150 Count	517 Count	75 Count
1790627372	149 Count	511 Count	75 Count
1790626469	147 Count	506 Count	74 Count
1790625565	145 Count	503 Count	73 Count
1790624662	143 Count	498 Count	72 Count
1790623759	141 Count	491 Count	71 Count
1790622855	139 Count	487 Count	70 Count
1790621952	137 Count	481 Count	69 Count
1790621049	135 Count	476 Count	68 Count
1790620145	133 Count	470 Count	67 Count
1790619242	131 Count	465 Count	66 Count
1790618339	130 Count	461 Count	66 Count
1790617435	128 Count	456 Count	65 Count
1790616532	126 Count	449 Count	64 Count
1790615628	124 Count	444 Count	63 Count
1790614725	122 Count	438 Count	62 Count
1790613821	121 Count	433 Count	62 Count
1790612918	119 Count	426 Count	61 Count
1790612018	117 Count	422 Count	60 Count
1790611111	113 Count	415 Count	59 Count
1790610287	112 Count	410 Count	59 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)