APRS Track Direct

My position About ☰

reset

F1GTH-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1GTH-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1780116198	121	32	255	169	130
1780115594	121	32	255	168	129
1780114993	121	32	255	170	132
1780114389	121	32	255	167	127
1780113788	121	32	255	171	135
1780113185	121	33	255	165	124
1780112584	121	33	255	167	127
1780111982	121	32	255	166	126
1780111381	121	32	255	173	137
1780110178	121	33	255	171	134
1780109584	121	33	255	168	129
1780108975	121	33	255	172	135
1780108374	121	33	255	165	124
1780107770	121	33	255	172	136
1780107167	121	33	255	173	138
1780106564	121	33	255	168	131
1780105962	121	33	255	166	126
1780105360	121	33	255	174	138
1780104758	121	33	255	170	133
1780104156	121	33	255	164	123
1780103554	121	33	255	169	131
1780102952	121	33	255	168	129
1780102351	121	33	255	167	128
1780101749	121	33	255	174	139
1780101144	121	33	255	173	137

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)