APRS Track Direct

My position About ☰

reset

PU1RMQ-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU1RMQ-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774129272	24	88	50	12	131
1774128664	24	86	50	11	132
1774128057	25	84	50	8	132
1774127453	24	86	50	12	131
1774126845	24	86	50	5	132
1774126246	25	86	49	9	132
1774125032	25	85	49	11	132
1774123822	24	87	49	13	132
1774122611	25	85	48	10	131
1774121391	24	87	40	10	131
1774120785	24	85	40	11	131
1774120176	24	83	40	12	131
1774119568	24	86	40	12	131
1774118960	24	87	39	11	131
1774118354	24	87	39	11	131
1774117748	24	89	39	12	131
1774117138	25	85	39	15	131
1774116525	24	87	39	12	131
1774115915	24	88	38	13	131
1774115308	24	92	38	11	131
1774114700	24	91	38	10	131
1774114094	24	90	38	4	131
1774113495	24	90	38	6	131
1774112893	24	90	38	6	131
1774112290	25	88	37	3	131

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)