APRS Track Direct

My position About ☰

reset

YM2KBI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YM2KBI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RSSI*	Voltage*
1836274776	-81 dBm	0.14 V
1836274398	-81 dBm	0.14 V
1836273882	-81 dBm	0.14 V
1766153285	-81 dBm	0.14 V
1766151130	-81 dBm	0.14 V
1766150315	-79 dBm	0.14 V
1766148447	-82 dBm	0.14 V
1766146730	-79 dBm	0.14 V
1766146269	-80 dBm	0.14 V
1766145515	-81 dBm	0.14 V
1766144767	-79 dBm	0.14 V
1766144046	-80 dBm	0.14 V
1766143306	-80 dBm	0.14 V
1766142588	-80 dBm	0.14 V
1766141845	-79 dBm	0.14 V
1766141128	-78 dBm	0.14 V
1766140572	-79 dBm	0.14 V
1766139666	-79 dBm	0.14 V
1766138974	-79 dBm	0.14 V
1766138318	-80 dBm	0.14 V
1766137508	-79 dBm	0.14 V
1766136795	-79 dBm	0.14 V
1766135045	-80 dBm	0.14 V
1766134332	-80 dBm	0.14 V
1766132776	-79 dBm	0.14 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)