APRS Track Direct

My position About ☰

reset

SV2RCS-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV2RCS-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1779821238	-87 dbm	11.77 V
1779820637	-82 dbm	11.77 V
1779820037	-77 dbm	11.77 V
1779819437	-87 dbm	11.77 V
1779818837	-86 dbm	11.79 V
1779818237	-81 dbm	11.79 V
1779817637	-74 dbm	11.79 V
1779817037	-79 dbm	11.81 V
1779816437	-76 dbm	11.83 V
1779815838	-72 dbm	11.81 V
1779815237	-73 dbm	11.83 V
1779814638	-73 dbm	11.81 V
1779814037	-72 dbm	11.83 V
1779813437	-73 dbm	11.83 V
1779812838	-73 dbm	11.83 V
1779812238	-77 dbm	11.85 V
1779811638	-77 dbm	11.83 V
1779811037	-74 dbm	11.83 V
1779810437	-85 dbm	11.85 V
1779809840	-82 dbm	11.85 V
1779809237	-85 dbm	11.85 V
1779808637	-84 dbm	11.85 V
1779808037	-86 dbm	11.85 V
1779807437	-85 dbm	11.85 V
1779806837	-74 dbm	11.86 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)