APRS Track Direct

My position About ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1790639651	158 Count	761 Count	45 Count
1790638450	157 Count	753 Count	45 Count
1790637248	156 Count	748 Count	45 Count
1790636048	155 Count	745 Count	45 Count
1790634847	154 Count	731 Count	45 Count
1790633647	153 Count	726 Count	45 Count
1790632446	152 Count	719 Count	45 Count
1790631245	151 Count	711 Count	45 Count
1790630045	150 Count	708 Count	45 Count
1790628844	149 Count	702 Count	45 Count
1790627644	148 Count	697 Count	45 Count
1790626443	147 Count	694 Count	45 Count
1790625242	146 Count	692 Count	45 Count
1790624042	145 Count	687 Count	45 Count
1790621650	139 Count	683 Count	45 Count
1790620449	138 Count	677 Count	45 Count
1790619249	137 Count	672 Count	45 Count
1790618048	136 Count	666 Count	45 Count
1790616847	135 Count	658 Count	45 Count
1790615647	134 Count	653 Count	45 Count
1790614446	129 Count	650 Count	45 Count
1790613246	118 Count	642 Count	45 Count
1790612045	93 Count	612 Count	45 Count
1790610844	92 Count	589 Count	45 Count
1790609644	91 Count	564 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)