APRS Track Direct

My position About ☰

reset

DH9SD-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DH9SD-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774113280	155	166	206	236	197
1774113225	155	168	214	230	189
1774113170	155	180	216	232	187
1774113115	155	164	204	226	179
1774113060	155	171	212	229	187
1774113005	155	172	216	227	181
1774112950	155	172	210	209	179
1774112895	155	174	219	224	196
1774112839	155	175	223	243	186
1774112784	155	176	208	239	202
1774112731	155	182	211	222	191
1774112674	155	192	214	230	191
1774112621	155	193	221	239	193
1774112564	155	191	227	235	199
1774112509	155	193	218	230	187
1774112454	155	192	203	232	178
1774112398	155	193	219	224	198
1774112343	155	188	217	221	196
1774112288	155	194	217	237	203
1774112233	155	194	218	236	201
1774112178	155	175	220	219	190
1774112123	155	172	216	228	188
1774112068	155	172	216	228	188
1774112013	155	172	216	220	190
1774111957	155	173	212	217	190

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)