APRS Track Direct

My position About ☰

reset

KQ6DI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782505357	569	826	918	39	64
1782504573	564	825	914	38	66
1782503555	548	828	918	37	98
1782501757	564	832	918	36	60
1782500973	564	833	923	35	71
1782499955	564	830	918	34	74
1782498157	558	817	905	33	71
1782497373	548	809	896	32	71
1782496355	542	799	887	31	71
1782494555	537	779	864	30	74
1782493772	532	770	856	29	68
1782492755	521	755	842	28	68
1782490958	505	716	797	27	62
1782490173	489	697	774	26	64
1782483756	419	615	680	21	98
1782481955	413	607	676	19	98
1782480155	413	606	676	18	98
1782478355	413	608	676	16	98
1782476555	419	612	680	15	98
1782474754	419	616	684	13	98
1782472955	424	619	684	12	98
1782471297	424	623	689	10	98
1782467555	429	633	712	7	98
1782464972	462	644	730	5	63
1782463955	462	641	720	4	64

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)