APRS Track Direct

My position About ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790658684	64 Count	165 Count	44 Count
1790657783	62 Count	158 Count	43 Count
1790656883	54 Count	142 Count	36 Count
1790655982	51 Count	133 Count	34 Count
1790655081	48 Count	125 Count	32 Count
1790654181	44 Count	115 Count	29 Count
1790653280	41 Count	106 Count	27 Count
1790652380	38 Count	91 Count	25 Count
1790652089	37 Count	89 Count	25 Count
1790651188	34 Count	80 Count	23 Count
1790650288	31 Count	73 Count	21 Count
1790649387	28 Count	67 Count	19 Count
1790648486	25 Count	60 Count	17 Count
1790647586	22 Count	54 Count	15 Count
1790646685	19 Count	48 Count	13 Count
1790645784	16 Count	38 Count	11 Count
1790644884	13 Count	34 Count	9 Count
1790643983	10 Count	26 Count	7 Count
1790643083	7 Count	20 Count	5 Count
1790642182	4 Count	12 Count	3 Count
1790641281	1 Count	5 Count	1 Count
1790640381	436 Count	1006 Count	287 Count
1790639480	433 Count	999 Count	285 Count
1790638583	430 Count	988 Count	283 Count
1790637679	427 Count	981 Count	281 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)