APRS Track Direct

My position About ☰

reset

SWANMT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SWANMT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782512420	128	33	63	41	48
1782511821	128	50	63	41	48
1782511216	128	29	63	41	48
1782510615	128	30	64	41	48
1782510011	128	34	96	41	80
1782509407	128	59	67	41	48
1782508807	129	30	63	41	48
1782507604	129	28	65	41	48
1782507001	126	61	65	38	48
1782506399	129	37	66	63	48
1782505799	130	33	66	64	48
1782505197	126	26	65	41	48
1782504595	130	29	65	41	48
1782503992	130	44	66	41	48
1782503390	129	31	66	41	48
1782502784	126	29	67	63	48
1782502182	126	29	67	41	48
1782501577	126	57	66	41	48
1782500975	126	58	69	41	48
1782500371	129	61	67	41	48
1782499767	130	29	97	41	74
1782499165	130	31	70	41	48
1782498563	129	62	69	41	48
1782497958	127	30	69	41	48
1782497356	122	30	70	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)