APRS Track Direct

My position About ☰

reset

EA5AZW-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5AZW-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1778054902	152	197	216	234	183
1778054847	152	196	215	227	174
1778054792	152	196	218	225	171
1778054737	152	198	220	240	168
1778054681	152	196	215	227	175
1778054626	152	197	216	234	184
1778054571	152	197	222	236	186
1778054516	152	197	219	239	188
1778054460	152	198	220	234	183
1778054405	152	198	224	245	185
1778054350	152	198	217	235	187
1778054295	152	198	221	235	185
1778054240	152	198	220	221	173
1778054184	151	198	217	235	188
1778054129	152	199	221	229	177
1778053736	151	199	222	243	184
1778053681	151	198	214	221	185
1778053625	150	197	223	244	189
1778053402	151	198	215	221	183
1778053292	151	197	216	234	186
1778053237	150	197	216	228	177
1778053182	150	198	214	228	184
1778053126	150	198	221	242	186
1778053071	149	198	224	246	193
1778053016	149	196	216	234	184

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)