APRS Track Direct

☰

reset

W6MAF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W6MAF-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1792179338	123	99	255	91	66
1792179217	123	98	255	91	67
1792179096	123	98	255	92	63
1792178976	122	97	255	92	68
1792178854	122	96	255	93	69
1792178733	123	95	255	93	70
1792178612	123	94	255	94	71
1792178491	123	92	255	95	73
1792178370	123	90	255	97	70
1792178249	123	88	255	98	76
1792178128	123	83	255	101	82
1792178007	124	76	255	68	41
1792147874	123	100	255	90	61
1792147753	123	100	255	91	61
1792147632	123	99	255	91	67
1792147511	123	98	255	91	67
1792147269	123	96	255	93	69
1792147148	123	95	255	94	68
1792147027	123	94	255	97	72
1792146906	123	91	255	98	74
1792146785	123	89	255	100	77
1792146664	123	84	255	103	82
1792146545	125	77	255	64	36

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)

Maintained by UW0WU-1, based on APRS Track Direct