APRS Track Direct

My position About ☰

reset

ECHO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ECHO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782509986	136	49	33	24	119
1782507435	136	49	32	23	119
1782504886	136	48	32	24	119
1782502336	136	48	32	24	119
1782499785	136	49	32	24	119
1782497236	136	48	32	23	117
1782492137	136	48	32	24	120
1782489585	136	48	32	24	119
1782487035	136	48	32	24	119
1782484485	136	48	32	23	119
1782481936	135	48	32	24	119
1782479385	136	48	32	23	119
1782476836	136	49	32	24	120
1782474285	136	48	32	24	116
1782471735	136	48	32	24	119
1782469185	136	48	32	23	117
1782466635	136	48	32	24	119
1782464085	136	48	32	24	119
1782461535	136	48	32	24	119
1782456435	136	48	32	23	119
1782453885	136	48	32	24	119
1782451335	136	48	32	23	119
1782448785	136	47	32	24	119
1782446235	136	48	32	24	119
1782443685	136	48	32	24	119

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)