APRS Track Direct

My position About ☰

reset

W1XM-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W1XM-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790642764	227	228	227	137	175
1790640957	227	227	226	155	178
1790639150	248	226	222	155	176
1790637344	224	229	230	155	178
1790635537	219	228	228	152	178
1790633732	226	229	307	155	179
1790631926	249	253	233	154	177
1790630119	227	230	289	155	176
1790628316	302	230	230	325	178
1790626513	285	225	226	154	174
1790624709	223	227	230	262	178
1790622899	228	228	229	152	176
1790621096	220	222	228	154	199
1790619291	259	230	233	150	176
1790617488	226	363	230	155	177
1790615681	219	226	228	153	178
1790613878	226	223	226	154	174
1790612076	261	224	225	155	174
1790610273	220	225	226	154	175
1790608467	223	226	223	153	176
1790606657	218	226	230	152	176
1790604854	278	233	233	336	178
1790603047	296	228	230	152	214
1790601240	225	229	265	152	176
1790599432	239	230	233	153	177

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)