APRS Track Direct

My position About ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782506202	530 Count	107 Count	91 Count
1782504401	529 Count	107 Count	91 Count
1782502601	528 Count	107 Count	91 Count
1782502334	527 Count	107 Count	91 Count
1782500544	526 Count	107 Count	91 Count
1782498743	525 Count	107 Count	91 Count
1782496942	524 Count	107 Count	91 Count
1782495142	523 Count	107 Count	91 Count
1782493341	522 Count	107 Count	91 Count
1782491540	521 Count	107 Count	91 Count
1782489739	520 Count	106 Count	91 Count
1782487939	519 Count	104 Count	91 Count
1782486138	514 Count	100 Count	87 Count
1782484337	513 Count	100 Count	87 Count
1782482536	512 Count	100 Count	87 Count
1782480736	511 Count	100 Count	87 Count
1782478941	507 Count	97 Count	84 Count
1782477140	500 Count	91 Count	78 Count
1782475339	499 Count	91 Count	78 Count
1782473539	498 Count	91 Count	78 Count
1782471738	497 Count	91 Count	78 Count
1782469937	496 Count	91 Count	78 Count
1782468136	495 Count	91 Count	78 Count
1782466336	494 Count	91 Count	78 Count
1782464535	493 Count	91 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)