APRS Track Direct

My position About ☰

reset

OK0BAD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0BAD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732274161	113	63	109	16	82
1732273262	113	55	109	16	82
1732272361	112	59	109	16	82
1732271461	113	59	109	16	82
1732270561	111	61	109	16	82
1732269662	104	57	109	15	82
1732268762	103	60	109	15	82
1732267861	104	56	109	15	82
1732266962	108	55	109	15	82
1732266062	110	57	109	15	82
1732265162	116	66	109	15	82
1732264262	115	65	109	15	82
1732263362	113	64	109	15	82
1732262462	108	61	109	15	82
1732261563	112	63	109	15	82
1732260662	117	68	109	15	82
1732259762	111	62	109	15	82
1732258862	112	62	109	15	82
1732257962	113	60	109	15	82
1732257062	115	61	109	15	82
1732256162	107	62	109	15	82
1732255262	110	62	109	15	82
1732254363	107	61	109	15	82
1732253463	106	57	109	15	82
1732252563	113	63	109	15	82

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)