APRS Track Direct

My position About ☰

reset

HS3LSE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS3LSE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1836274816	-58 dBm	0.21 V
1762323538	-66 dBm	0.06 V
1762320811	-68 dBm	0.21 V
1762318024	-63 dBm	0.21 V
1762315296	-60 dBm	0.21 V
1762312506	-68 dBm	0.21 V
1762309779	-62 dBm	0.06 V
1762306991	-60 dBm	0.21 V
1762304227	-58 dBm	0.06 V
1762301439	-60 dBm	0.06 V
1762298711	-60 dBm	0.04 V
1762295925	-58 dBm	0.06 V
1762293199	-58 dBm	0.06 V
1762290412	-59 dBm	0.06 V
1762287685	-60 dBm	0.21 V
1762284899	-59 dBm	0.21 V
1762282172	-60 dBm	0.21 V
1762279386	-59 dBm	0.21 V
1762276659	-59 dBm	0.21 V
1762273872	-61 dBm	0.21 V
1762271146	-61 dBm	0.21 V
1762268357	-58 dBm	0.21 V
1762265618	-62 dBm	0.08 V
1762262831	-62 dBm	0.21 V
1762260105	-61 dBm	0.21 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)