APRS Track Direct

My position About ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782502388	75 Count	600 Count	9 Count
1782500587	74 Count	548 Count	9 Count
1782498797	57 Count	496 Count	5 Count
1782496996	53 Count	456 Count	4 Count
1782495195	52 Count	440 Count	4 Count
1782493394	51 Count	420 Count	4 Count
1782491593	50 Count	398 Count	4 Count
1782489792	49 Count	373 Count	4 Count
1782487991	48 Count	354 Count	4 Count
1782486190	40 Count	330 Count	4 Count
1782484389	31 Count	305 Count	4 Count
1782482588	20 Count	284 Count	4 Count
1782480787	13 Count	248 Count	4 Count
1782478986	12 Count	224 Count	4 Count
1782477196	10 Count	206 Count	3 Count
1782475395	6 Count	177 Count	0 Count
1782473594	5 Count	147 Count	0 Count
1782471793	4 Count	108 Count	0 Count
1782469992	3 Count	78 Count	0 Count
1782468191	2 Count	57 Count	0 Count
1782466390	1 Count	38 Count	0 Count
1782464589	0 Count	13 Count	0 Count
1782462788	64 Count	1015 Count	0 Count
1782460987	63 Count	988 Count	0 Count
1782459186	62 Count	956 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)