APRS Track Direct

My position About ☰

reset

HK3ZTU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HK3ZTU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774377549	255	71	48	43	47
1774377051	255	61	38	32	39
1774376749	255	63	41	36	41
1774376448	255	69	48	40	46
1774373793	255	67	44	38	44
1774373601	255	59	37	31	37
1774373300	255	61	39	33	38
1774372999	255	63	40	35	40
1774372698	255	65	43	37	42
1774372397	255	69	47	39	45
1774372096	255	73	50	43	48
1774366534	255	82	59	52	57
1774364182	255	72	49	46	50
1774352690	255	70	47	41	46
1774352389	255	72	48	42	48
1774351183	255	81	57	50	56
1774349308	255	91	66	58	64
1774349007	255	71	48	46	49
1774314853	255	86	64	55	60
1774311545	255	84	61	54	60
1774311244	255	90	66	58	64

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)