APRS Track Direct

My position About ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782508932	567 Count	708 Count	268 Count
1782508326	565 Count	706 Count	267 Count
1782507720	563 Count	705 Count	266 Count
1782507341	562 Count	704 Count	266 Count
1782506735	560 Count	703 Count	265 Count
1782506129	559 Count	703 Count	265 Count
1782505523	557 Count	700 Count	264 Count
1782504917	555 Count	698 Count	263 Count
1782504310	554 Count	697 Count	263 Count
1782503704	552 Count	695 Count	262 Count
1782503098	550 Count	692 Count	261 Count
1782502491	549 Count	691 Count	261 Count
1782501885	547 Count	688 Count	260 Count
1782501279	545 Count	686 Count	259 Count
1782500672	544 Count	685 Count	259 Count
1782500066	542 Count	682 Count	258 Count
1782499460	540 Count	679 Count	257 Count
1782498854	539 Count	678 Count	257 Count
1782498248	537 Count	675 Count	256 Count
1782497641	535 Count	672 Count	255 Count
1782497035	534 Count	671 Count	255 Count
1782496429	532 Count	670 Count	254 Count
1782495823	530 Count	667 Count	253 Count
1782495217	529 Count	667 Count	253 Count
1782494610	527 Count	666 Count	252 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)