APRS Track Direct

My position About ☰

reset

WB6ETY-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1775962471	1377	772	381	770	41
1775961790	1372	773	376	770	38
1775961750	1369	773	386	770	39
1775961031	1372	774	381	770	41
1775960311	1372	774	381	770	43
1775959990	1374	773	381	770	42
1775959591	1374	772	381	770	44
1775958870	1372	773	386	770	43
1775958190	1372	774	381	770	39
1775958149	1374	774	386	770	37
1775957430	1372	776	386	774	35
1775956710	1372	778	386	774	42
1775956390	1372	779	386	774	32
1775955990	1372	779	386	774	36
1775955270	1374	779	386	774	40
1775954591	1375	779	381	774	33
1775954550	1372	778	386	774	32
1775953830	1372	778	386	774	36
1775953111	1372	778	381	774	37
1775952790	1359	777	381	770	36
1775952390	1372	777	392	770	37
1775951671	1374	777	386	770	38
1775950990	1372	776	381	770	37
1775950950	1372	776	381	770	33
1775950231	1369	776	386	770	42

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)