APRS Track Direct

My position About ☰

reset

F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1778027609	53 Count	984 Count
1778025805	52 Count	961 Count
1778024001	51 Count	938 Count
1778022197	50 Count	916 Count
1778020394	49 Count	893 Count
1778018590	48 Count	875 Count
1778016786	47 Count	854 Count
1778014982	46 Count	831 Count
1778009570	43 Count	771 Count
1778007766	42 Count	747 Count
1778006006	37 Count	725 Count
1778002398	35 Count	679 Count
1778000594	34 Count	655 Count
1777998791	33 Count	632 Count
1777996987	32 Count	604 Count
1777995183	31 Count	580 Count
1777993379	30 Count	551 Count
1777991575	29 Count	527 Count
1777987967	27 Count	476 Count
1777986163	26 Count	452 Count
1777984403	21 Count	435 Count
1777980795	19 Count	380 Count
1777978992	18 Count	354 Count
1777975384	16 Count	305 Count
1777969972	13 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)