APRS Track Direct

My position About ☰

reset

JJ2YAA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JJ2YAA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790642183	120	36	999	680	532
1790640385	120	36	999	680	533
1790638587	120	36	999	680	533
1790636789	120	36	999	679	532
1790634991	120	36	999	679	532
1790633192	120	37	999	679	531
1790631394	120	36	999	680	532
1790629596	120	37	999	679	531
1790627798	120	37	999	678	530
1790626000	120	37	999	678	530
1790624202	120	37	999	677	529
1790622404	120	38	999	676	527
1790620606	120	38	999	675	526
1790618807	120	38	999	676	527
1790617009	120	38	999	675	525
1790615211	120	38	999	676	526
1790613413	120	39	999	676	526
1790611615	120	39	999	675	525
1790609817	120	39	999	675	526
1790608019	120	39	999	675	525
1790606221	120	39	999	675	525
1790604423	120	38	999	675	526
1790602624	120	39	999	675	526
1790600826	120	39	999	675	525
1790599028	120	38	999	675	526

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)