APRS Track Direct

My position About ☰

reset

EA1BVF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA1BVF-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732287086	57	2	81	188	131
1732285885	61	2	81	189	131
1732284684	62	2	81	189	131
1732283483	61	1	81	191	131
1732282282	67	2	81	192	131
1732281081	74	2	81	192	130
1732279879	82	3	81	193	129
1732278678	77	2	81	193	129
1732277477	77	2	81	192	128
1732276276	73	2	81	193	128
1732275075	71	2	81	193	128
1732273873	66	2	81	192	128
1732272672	64	2	81	190	128
1732271471	65	2	81	195	130
1732270270	64	2	81	195	131
1732269069	63	2	81	196	130
1732267868	71	1	81	202	132
1732266667	73	2	81	198	130
1732265465	76	2	81	199	130
1732264264	76	3	81	191	128
1732263063	73	3	81	183	128
1732261862	73	3	81	155	125
1732260661	66	1	81	148	125
1732259460	68	1	81	148	125
1732258259	65	2	81	148	125

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)