APRS Track Direct

My position About ☰

reset

N7SHM-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N7SHM-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732287031	132	87	999	659	489
1732285231	132	86	997	660	491
1732281631	132	87	999	658	487
1732279832	132	86	999	658	489
1732278034	132	86	998	660	491
1732276235	132	87	999	658	486
1732274437	132	88	999	658	487
1732272639	132	86	997	660	488
1732270841	132	86	999	659	487
1732269042	132	86	997	658	488
1732267244	132	86	999	659	489
1732265446	132	87	999	659	488
1732263648	132	86	999	658	485
1732261850	132	86	999	659	488
1732260052	132	86	999	659	487
1732258253	132	87	999	659	488
1732256455	132	86	999	658	488
1732254657	132	87	999	659	487
1732252859	132	87	999	658	487
1732251061	132	87	999	661	489
1732250078	132	87	997	659	488
1732248262	133	86	999	658	485
1732246462	132	86	999	659	488
1732244662	133	86	999	658	486
1732242862	132	86	999	658	485

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)