APRS Track Direct

My position About ☰

reset

YO4CIL-MG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO4CIL-MG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1773563334	-72 dbm	1.54 V
1773562734	-71 dbm	1.53 V
1773562134	-72 dbm	1.42 V
1773561534	-78 dbm	1.78 V
1773560940	-76 dbm	1.97 V
1773560334	-78 dbm	1.89 V
1773559861	-76 dbm	1.78 V
1773559134	-71 dbm	1.7 V
1773558556	-71 dbm	1.62 V
1773557334	-71 dbm	1.79 V
1773556734	-68 dbm	2.16 V
1773556134	-69 dbm	2.12 V
1773555611	-75 dbm	2.35 V
1773554934	-75 dbm	2.31 V
1773554336	-84 dbm	1.86 V
1773553151	-72 dbm	1.31 V
1773552540	-81 dbm	0.72 V
1773551934	-79 dbm	1.09 V
1773551248	-72 dbm	0.48 V
1773550134	-73 dbm	0.34 V
1773550091	-73 dbm	0.31 V
1773548934	-73 dbm	0.25 V
1773548334	-73 dbm	0.19 V
1773547733	-73 dbm	0.16 V
1773546534	-73 dbm	0.14 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)