APRS Track Direct

My position About ☰

reset

SP3KON-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1774068459	184 Count	379 Count	49 Count
1774067558	181 Count	371 Count	47 Count
1774066657	178 Count	363 Count	45 Count
1774065756	175 Count	355 Count	43 Count
1774064855	172 Count	347 Count	41 Count
1774063955	170 Count	340 Count	40 Count
1774063054	166 Count	330 Count	37 Count
1774062153	164 Count	322 Count	36 Count
1774061271	161 Count	314 Count	34 Count
1774060370	154 Count	301 Count	32 Count
1774059469	141 Count	278 Count	28 Count
1774058568	131 Count	260 Count	27 Count
1774057667	122 Count	243 Count	25 Count
1774056766	114 Count	231 Count	24 Count
1774055865	106 Count	214 Count	23 Count
1774054964	95 Count	193 Count	20 Count
1774054063	85 Count	175 Count	17 Count
1774053162	74 Count	150 Count	14 Count
1774052261	65 Count	131 Count	12 Count
1774051361	53 Count	107 Count	9 Count
1774050460	42 Count	87 Count	7 Count
1774049559	31 Count	66 Count	4 Count
1774048658	18 Count	44 Count	2 Count
1774047757	569 Count	1011 Count	78 Count
1774046856	553 Count	984 Count	76 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)