APRS Track Direct

My position About ☰

reset

SP6FIG-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6FIG-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1782501745	-49 dbm	3.02 V
1782501445	-46 dbm	3.02 V
1782501145	-38 dbm	3.02 V
1782500845	-32 dbm	3.02 V
1782500545	-34 dbm	3.02 V
1782500245	-37 dbm	3.02 V
1782499945	-32 dbm	3.02 V
1782499645	-26 dbm	3.02 V
1782499345	-31 dbm	3.02 V
1782499045	-40 dbm	3.02 V
1782498745	-35 dbm	3.02 V
1782498445	-32 dbm	3.02 V
1782498145	-31 dbm	3.02 V
1782497845	-37 dbm	3.02 V
1782497545	-27 dbm	3.02 V
1782497245	-27 dbm	3.02 V
1782496945	-30 dbm	3.02 V
1782496645	-30 dbm	3.02 V
1782496345	-32 dbm	3.02 V
1782496045	-28 dbm	3.02 V
1782495745	-28 dbm	3.02 V
1782495445	-26 dbm	3.02 V
1782495145	-27 dbm	3.02 V
1782494845	-26 dbm	3.02 V
1782494545	-31 dbm	3.02 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)