APRS Track Direct

My position About ☰

reset

KG7FOQ-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KG7FOQ-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732288687	129	51	126	110	100
1732288146	129	51	126	110	100
1732287605	129	51	126	110	101
1732287063	129	51	126	110	100
1732286522	129	51	126	110	100
1732285980	129	52	126	110	100
1732285439	129	51	126	110	100
1732284898	129	51	126	110	100
1732284357	129	52	126	109	100
1732283816	129	52	126	110	100
1732283275	128	52	126	109	99
1732282734	129	52	126	110	100
1732282193	129	52	126	109	100
1732281651	129	52	126	110	104
1732281109	129	53	126	109	104
1732280568	129	52	126	109	103
1732280027	129	52	126	110	100
1732279485	129	52	126	110	100
1732278944	129	52	126	110	100
1732278403	129	52	126	109	100
1732277861	129	53	126	109	100
1732277320	129	53	126	109	100
1732276778	128	53	126	110	100
1732276237	129	53	126	110	100
1732275696	129	53	126	109	99

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)