APRS Track Direct

My position About ☰

reset

YC2SNK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2SNK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1782562503	43 Count	362 Count
1782560699	42 Count	351 Count
1782558895	41 Count	342 Count
1782557091	40 Count	340 Count
1782555287	39 Count	338 Count
1782553479	38 Count	336 Count
1782551675	37 Count	333 Count
1782549871	36 Count	330 Count
1782548067	35 Count	329 Count
1782546264	34 Count	323 Count
1782544460	33 Count	318 Count
1782542656	32 Count	314 Count
1782540899	31 Count	309 Count
1782539096	30 Count	306 Count
1782537292	29 Count	301 Count
1782535487	28 Count	292 Count
1782533683	27 Count	282 Count
1782531879	26 Count	262 Count
1782530075	25 Count	245 Count
1782528271	24 Count	232 Count
1782526467	23 Count	218 Count
1782524663	22 Count	204 Count
1782522859	21 Count	189 Count
1782521055	20 Count	172 Count
1782520186	19 Count	172 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)