APRS Track Direct

My position About ☰

reset

ZL1UHF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL1UHF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*
1836274272	149	177	175	27
1836274121	150	180	179	27
1766291468	150	148	146	27
1766290566	150	141	140	27
1766289637	150	142	140	27
1766288250	150	146	144	27
1766287349	150	150	149	27
1766286447	150	152	151	27
1766285546	150	153	152	27
1766284644	150	149	148	27
1766283743	150	144	143	27
1766282841	150	155	155	27
1766281940	150	146	145	27
1766281038	150	142	140	27
1766280100	150	155	154	27
1766279198	150	158	157	27
1766278297	150	158	157	27
1766277395	150	156	155	27
1766276494	150	161	160	27
1766275592	149	158	158	27
1766274691	149	160	159	27
1766273789	149	157	156	27
1766272888	149	142	141	27
1766271968	149	154	153	27
1766271067	148	141	140	27

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)