APRS Track Direct

My position About ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786722911	372 Count	980 Count	67 Count
1786722310	371 Count	979 Count	67 Count
1786721709	370 Count	978 Count	67 Count
1786721109	369 Count	977 Count	67 Count
1786720508	368 Count	976 Count	67 Count
1786719937	363 Count	975 Count	67 Count
1786719336	362 Count	974 Count	67 Count
1786718735	361 Count	973 Count	67 Count
1786718135	360 Count	972 Count	67 Count
1786717534	359 Count	971 Count	67 Count
1786716933	358 Count	971 Count	67 Count
1786716332	357 Count	970 Count	67 Count
1786715731	356 Count	969 Count	67 Count
1786715130	355 Count	968 Count	67 Count
1786714529	354 Count	967 Count	67 Count
1786713929	353 Count	966 Count	67 Count
1786713328	352 Count	965 Count	67 Count
1786712727	351 Count	965 Count	67 Count
1786712126	350 Count	964 Count	67 Count
1786711525	349 Count	963 Count	67 Count
1786710924	348 Count	962 Count	67 Count
1786710323	347 Count	961 Count	67 Count
1786709722	346 Count	961 Count	67 Count
1786709121	345 Count	960 Count	67 Count
1786708521	344 Count	959 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)