APRS Track Direct

My position About ☰

reset

PANDO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PANDO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732279745	112	21	72	41	48
1732277942	112	22	72	66	49
1732276139	112	22	72	41	48
1732274336	112	21	71	41	48
1732272534	112	20	98	43	74
1732270730	113	21	72	41	48
1732268926	112	22	99	42	74
1732267123	112	24	72	41	48
1732265323	112	24	72	41	48
1732263517	113	22	72	42	48
1732261715	114	21	72	41	48
1732259912	113	17	72	41	48
1732258109	114	25	72	65	49
1732256306	115	20	99	42	74
1732254503	114	22	70	41	48
1732252701	114	21	70	66	49
1732250897	115	22	72	42	48
1732249096	115	31	71	41	48
1732247291	115	24	100	42	74
1732245488	115	33	71	41	48
1732243686	115	22	70	42	48
1732241883	115	21	70	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)