APRS Track Direct

My position About ☰

reset

KB5SQG-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KB5SQG-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value2*	Value3*	Value4*	Value5*
1782518067	101	255	190	158
1782513101	109	255	187	154
1782512975	106	255	188	155
1782512002	106	255	188	155
1782511876	104	255	189	156
1782510945	99	255	191	160
1782508659	102	255	189	156
1782498298	98	255	191	159
1782496470	109	255	188	153
1782496343	109	255	188	153
1782496217	109	255	187	153
1782496088	109	255	188	153
1782495836	108	255	187	154
1782495583	107	255	188	154
1782495456	106	255	188	155
1782495330	105	255	189	156
1782494613	104	255	189	155
1782494484	104	255	189	155
1782494356	104	255	189	156
1782494229	103	255	189	156
1782493847	100	255	190	158
1782493721	97	255	191	159
1782493372	93	255	193	163
1782491507	103	255	189	156
1782491254	102	255	189	157

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)