APRS Track Direct

My position About ☰

reset

W6PKT-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W6PKT-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274633	13.5	118	2	3	116
1782498692	13.5	118	2	3	116
1782496142	13.5	118	2	3	115
1782493592	13.5	118	2	3	116
1782491042	13.5	118	2	3	116
1782488492	13.5	118	2	3	116
1782485942	13.5	117	2	3	116
1782483392	13.5	117	2	3	116
1782480842	13.5	120	2	3	116
1782478292	13.5	116	2	3	116
1782475742	13.5	117	2	3	116
1782473192	13.5	120	2	3	116
1782470642	13.5	120	2	3	116
1782468092	13.5	118	2	3	116
1782465542	13.5	121	2	3	116
1782462992	13.5	119	2	3	116
1782460442	13.5	121	2	3	116
1782457892	13.5	121	2	3	116
1782455342	13.5	119	2	3	116
1782452792	13.5	120	2	3	116
1782450241	13.5	117	2	3	116
1782447691	13.5	120	2	3	116
1782445141	13.5	119	2	3	116
1782442591	13.5	121	2	3	116
1782440041	13.5	116	2	3	116

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)