APRS Track Direct

My position About ☰

reset

SQ2ODE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766311258	410 Count	663 Count
1766309457	409 Count	662 Count
1766307657	408 Count	661 Count
1766305856	407 Count	660 Count
1766304055	406 Count	659 Count
1766302255	405 Count	658 Count
1766300454	404 Count	657 Count
1766298654	403 Count	656 Count
1766296853	402 Count	655 Count
1766295059	401 Count	654 Count
1766293258	400 Count	653 Count
1766291458	399 Count	652 Count
1766289657	398 Count	651 Count
1766287857	397 Count	650 Count
1766286056	396 Count	649 Count
1766284255	395 Count	648 Count
1766282455	394 Count	647 Count
1766280654	393 Count	646 Count
1766278854	392 Count	645 Count
1766277053	391 Count	644 Count
1766275256	390 Count	643 Count
1766273458	389 Count	642 Count
1766271658	388 Count	641 Count
1766269857	387 Count	640 Count
1766268056	386 Count	639 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)