APRS Track Direct

My position About ☰

reset

PY5MOR-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5MOR-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1790637777	127	15	0	127
1790637417	127	15	0	127
1790637057	127	15	0	127
1790636694	128	15	0	128
1790635976	127	14	0	128
1790635248	127	14	0	127
1790634519	125	13	0	125
1790634159	128	13	0	128
1790633798	128	13	0	128
1790633437	127	13	0	128
1790633076	128	13	0	128
1790632716	128	13	0	128
1790632355	127	13	0	128
1790631995	128	13	0	128
1790631634	128	13	1	128
1790630913	128	12	14	128
1790630552	127	12	60	128
1790630426	128	13	66	128
1790629705	127	14	67	128
1790628982	128	13	67	129
1790628622	128	13	68	129
1790628261	128	13	67	128
1790627901	128	12	77	129
1790627540	128	12	98	128
1790627179	128	12	74	129

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)