APRS Track Direct

My position About ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786744229	659 Count	479 Count	380 Count
1786743325	657 Count	478 Count	379 Count
1786742422	655 Count	477 Count	378 Count
1786741518	653 Count	476 Count	377 Count
1786740614	651 Count	475 Count	376 Count
1786739710	649 Count	474 Count	375 Count
1786738807	647 Count	473 Count	374 Count
1786737903	645 Count	472 Count	373 Count
1786736999	643 Count	471 Count	372 Count
1786736095	641 Count	470 Count	371 Count
1786735191	639 Count	469 Count	370 Count
1786734287	636 Count	467 Count	368 Count
1786733383	634 Count	466 Count	367 Count
1786732480	632 Count	465 Count	366 Count
1786731576	630 Count	464 Count	365 Count
1786730672	627 Count	462 Count	363 Count
1786729860	625 Count	461 Count	362 Count
1786728961	623 Count	460 Count	361 Count
1786728052	621 Count	459 Count	360 Count
1786727148	618 Count	457 Count	358 Count
1786726244	616 Count	456 Count	357 Count
1786725340	614 Count	455 Count	356 Count
1786724437	612 Count	454 Count	355 Count
1786723533	609 Count	452 Count	353 Count
1786722629	607 Count	451 Count	352 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)