APRS Track Direct

My position About ☰

reset

SP6PTT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PTT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790646577	150 Count	831 Count	140 Count
1790644776	128 Count	688 Count	119 Count
1790642976	104 Count	556 Count	97 Count
1790641175	79 Count	414 Count	73 Count
1790639374	48 Count	269 Count	47 Count
1790637573	20 Count	124 Count	20 Count
1790635786	197 Count	1042 Count	187 Count
1790633984	164 Count	894 Count	156 Count
1790632182	136 Count	751 Count	129 Count
1790630380	110 Count	623 Count	105 Count
1790628578	89 Count	522 Count	86 Count
1790626777	61 Count	370 Count	60 Count
1790624976	27 Count	198 Count	27 Count
1790623175	269 Count	1118 Count	174 Count
1790621375	243 Count	977 Count	149 Count
1790619574	225 Count	854 Count	132 Count
1790617773	201 Count	716 Count	110 Count
1790615972	175 Count	576 Count	85 Count
1790614182	163 Count	509 Count	74 Count
1790612381	159 Count	507 Count	73 Count
1790610580	128 Count	383 Count	59 Count
1790608779	93 Count	229 Count	40 Count
1790606978	31 Count	74 Count	9 Count
1790605177	315 Count	1091 Count	217 Count
1790603376	285 Count	955 Count	199 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)