APRS Track Direct

My position About ☰

reset

N1SWT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N1SWT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	DigiRpt*	Temp*
1790663336	281 Pkts	184 Pkts	2 C
1790659738	321 Pkts	200 Pkts	2 C
1790652537	271 Pkts	187 Pkts	2 C
1790648937	216 Pkts	137 Pkts	2 C
1790645336	3 Pkts	3 Pkts	2 C
1790641736	3 Pkts	3 Pkts	2 C
1790638136	3 Pkts	3 Pkts	2 C
1790634536	32 Pkts	26 Pkts	2 C
1790630936	107 Pkts	91 Pkts	2 C
1790627336	137 Pkts	105 Pkts	3 C
1790623736	84 Pkts	52 Pkts	3 C
1790620136	105 Pkts	76 Pkts	3 C
1790612937	125 Pkts	82 Pkts	2 C
1790609337	261 Pkts	207 Pkts	3 C
1790605736	234 Pkts	181 Pkts	3 C
1790602136	196 Pkts	164 Pkts	3 C
1790598536	237 Pkts	178 Pkts	3 C
1790594940	235 Pkts	161 Pkts	4 C
1790591335	124 Pkts	79 Pkts	3 C
1790587735	269 Pkts	173 Pkts	4 C
1790584135	257 Pkts	179 Pkts	4 C
1790580534	236 Pkts	159 Pkts	4 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)