APRS Track Direct

My position About ☰

reset

KG7FOQ-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KG7FOQ-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790645113	131	82	123	101	89
1790644572	132	82	123	101	90
1790644030	134	82	123	101	90
1790643489	134	83	123	101	90
1790642948	136	83	123	100	89
1790642407	137	84	123	101	89
1790641867	138	84	123	100	88
1790640784	139	85	123	100	88
1790640242	139	85	123	100	89
1790639701	139	85	123	100	89
1790639160	139	86	123	100	89
1790638619	138	86	123	100	89
1790638078	139	86	123	100	88
1790637537	138	86	123	100	88
1790636996	138	86	123	99	87
1790636455	138	87	123	100	88
1790635913	138	86	123	100	88
1790635372	138	86	123	100	88
1790634831	139	86	123	100	88
1790634290	139	86	123	100	88
1790633749	138	86	123	100	89
1790633208	138	85	123	100	89
1790632667	139	85	123	100	89
1790632126	138	85	123	100	88
1790631584	139	85	123	100	89

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)